Anode
Mostrando 1-12 de 210 artigos, teses e dissertações.
-
1. AMORPHOUS CUSEP2/GRAPHENE COMPOSITES AS ANODE MATERIAL FOR ADVANCED POTASSIUM-ION BATTERY
The ternary amorphous CuSeP2 was designed and prepared as the anode material of potassium ion battery for the first time, and its electrochemical performance was also investigated. After ball-milling with commercial graphene powder, it is used as the anode material for potassium ion battery with reversible specific capacity up to 300 mAh g-1, and the corresp
Química Nova. Publicado em: 2022
-
2. Effect of Multi-Pass Rolling on the Performance of AZ31 Magnesium Alloy Anode in Mg-Air Battery
In this work, the influence of rolling passes on microstructure, corrosion behavior, electrochemical performance, and battery performance of AZ31 magnesium alloy was studied. The experimental results show that the grain size decreases first and then increases with rolling passes. Among them, the grain size of three passes rolled sample is the smallest, while
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
3. Enhanced Catalytic Performance of Strontium-Doped Lanthanum Manganites by the Presence of Molybdenum Oxides for Electro-Reduction of Hydrogen Peroxide
In this work, two catalysts, lanthanum manganite strontium-doped perovskite without (LSM) and with (LSMMO) mixed molybdenum oxides, were synthesized by the sol-gel route and deposited by immersion in carbon cloth substrates. Their performance as cathodes in the hydrogen peroxide reduction reaction (HPRR) and oxygen reduction reaction (ORR) was investigated t
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
4. CÉLULAS ELETROLÍTICA E A COMBUSTÍVEL CONFECCIONADAS COM MATERIAIS ALTERNATIVOS PARA O ENSINO DE ELETROQUÍMICA
The proposal addresses the electrochemical experimentation as a pedagogical instrument for the integral and dynamic student involvement, facilitating the teaching-learning process. The experimental proposal focuses on the conversion of electrical energy to chemical energy and vice versa. The experiments for the two simultaneous energy conversions were design
Quím. Nova. Publicado em: 2021-01
-
5. ANODES FOR SOFC: REVIEW OF MATERIAL SELECTION, INTERFACE AND ELECTROCHEMICAL PHENOMENA
This paper presents a comprehensive interface and electrochemical phenomena review of different anodes for SOFC. In this way, it was possible to select some mixed electronic and ionic conductor materials alternatives to the conventional anode, Ni-YSZ conductor. New materials must present a satisfactory electronic and ionic conductivity at intermediate temper
Quím. Nova. Publicado em: 2021-01
-
6. REMEDIACIÓN ELECTROCINÉTICA DE UN SUELO REAL CONTAMINADO CON PLOMO ASISTIDA CON LA ADICIÓN DE UN AGENTE COMPLEJANTE
The use of ethylenediaminetetraacetic acid disodium salt (Na2EDTA) as a chelating agent presents ideal characteristics to be used for the removal of lead from a contaminated site. Batch experiments together with a simple local equilibrium model were carried out to evaluate the role of EDTA as enhancing agent in electrokinetic remediation of a Pb-contaminated
Quím. Nova. Publicado em: 2020-09
-
7. ELECTROCHEMICAL INCINERATION OF SHORT-CHAIN CARBOXYLIC ACIDS WITH NB‑SUPPORTED BORON DOPED DIAMOND ANODE: SUPPORTING ELECTROLYTE EFFECT INTO THE ELECTROGENERATED OXIDANT SPECIES (HYDROXYL RADICALS, HYDROGEN PEROXIDE AND PERSULFATE)
This work describes the electrochemical oxidation study of three short chain carboxylic acids (acetic, oxalic and formic 0.18 mol L-1) using different electrolysis conditions (electrolyte composition and current density) in an electrochemical reactor fitted with niobiumsupported/BDD electrode (Nb/BBD) as anode and titanium plate as cathode. The experiments w
Quím. Nova. Publicado em: 2020-03
-
8. Hydrogen Peroxide Electrogeneration by Gas Diffusion Electrode Modified With Tungsten Oxide Nanoparticles for Degradation of Orange II and Sunset Yellow FCF Azo Dyes
In this work, the gas diffusion electrode (GDE) cathode of Vulcan XC72 carbon modified with nanoparticles of WO2.72 (WO2.72 / Vulcan XC72) was used for H2O2 electrogeneration and degradation of 350 mL of Orange II (OII) and Sunset Yellow FCF (SY) azo dyes by electro-Fenton (EF) and photoelectro-Fenton (PEF) processes with different Fe2+ initial content (1.00
J. Braz. Chem. Soc.. Publicado em: 16/09/2019
-
9. BDD-Electrolysis of Oxalic Acid in Diluted Acidic Solutions
Boron doped diamond films (BDD) are the most studied electrocatalytic materials and their efficiency for removing organic compounds is attributed to their ability to produce a large amount of hydroxyl radicals by the electrolysis of water. However, some organic compounds are easy to degrade than others, as well as they also interact with BDD surface. Thus, i
J. Braz. Chem. Soc.. Publicado em: 04/07/2019
-
10. Transcranial direct current stimulation (tDCS) in elderly with mild cognitive impairment: A pilot study
RESUMO. A ETCC (estimulação transcraniana por corrente contínua) é uma tecnologia não-invasiva, indolor e de fácil utilização. Pode ser usada na depressão, esquizofrenia e outros distúrbios neurológicos. Não há orientações ideais sobre o uso de protocolos mais longos quanto à duração e frequência semanal da ETCC. Objetivo: estudar o uso d
Dement. neuropsychol.. Publicado em: 18/06/2019
-
11. Evaluation of Potential Residual Silica as Antireflective Layer for Selective Solar Surface of Black Chromium
Selective surfaces have the function of absorbing strongly the sunlight, while ideally losing little heat to the environment via convection and radiation. The present study sought to obtain a selective surface of black chromium coated with an antireflective (AR) layer based on sugarcane bagasse ash using copper as a substrate. From this selective surface the
Mat. Res.. Publicado em: 03/06/2019
-
12. Doped Silicon Nanowires for Lithium Ion Battery Anodes
Nanostructured silicon (Si) has showed outstanding results as Li-ion battery anode material. Fabrication of nanostructured silicon anode materials is usually very complex, time consuming and expensive. In this work, silicon nanowires (SiNW`s) were produced by using rapid and uncostly metal catalyzed electroless etching (MCEE) method from various silicon wafe
Mat. Res.. Publicado em: 17/01/2019