Anodic Effect
Mostrando 1-12 de 47 artigos, teses e dissertações.
-
1. Effect of Multi-Pass Rolling on the Performance of AZ31 Magnesium Alloy Anode in Mg-Air Battery
In this work, the influence of rolling passes on microstructure, corrosion behavior, electrochemical performance, and battery performance of AZ31 magnesium alloy was studied. The experimental results show that the grain size decreases first and then increases with rolling passes. Among them, the grain size of three passes rolled sample is the smallest, while
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
2. Aqueous Extract of Cumaru (Dipteryx odorata) Seeds as Corrosion Inhibitor for Mild Steel in Hydrochloric Acid Solution
The corrosion inhibition of mild steel by aqueous extract of cumaru (Dipteryx odorata) seeds and its high molecular weight fraction (HMWF) was investigated in 1 mol L-1 HCl solution. The study was carried out through gravimetric essays, open circuit potential measurements, anodic and cathodic polarization curves and electrochemical impedance analyses, as wel
J. Braz. Chem. Soc.. Publicado em: 2021-02
-
3. Corrosion Resistance of Cu-Alloyed Precipitation Hardenable Duplex Stainless Steel ASTM A890 Grade 1B
Duplex stainless steels (DSS) are corrosion resistant alloys largely used in chemical and petrochemical industries. Some commercial DSS contain 0.5-1.0% copper addition to improve the corrosion resistance by reducing the corrosion rate in non-oxidizing environments. Higher copper addition (≥ 2%) can also hard by precipitation, especially when fine copper p
Mat. Res.. Publicado em: 07/11/2019
-
4. Scanning Electrochemical Microscopy (SECM) Study of the Electrochemical Behavior of Anodized AZ31B Magnesium Alloy in Simulated Body Fluid
In this work, scanning electrochemical microscopy (SECM) was employed to study the corrosion behavior of anodized AZ31B magnesium alloy exposed to simulated body fluid. SECM measurements were carried out in surface generation/tip collection mode. The hydrogen evolution flux caused during corrosion of the magnesium alloy was oxidized at the ultra-microelectro
Mat. Res.. Publicado em: 28/10/2019
-
5. Glycerol Effect on the Corrosion Resistance and Electrodeposition Conditions in a Zinc Electroplating Process
Zinc electrodeposition is an economical process of Zn coating compared to conventional galvanic process. The galvanizing process is used in various industrial sectors to protect ferrous alloys during the corrosion process. In buildings, the galvanizing process is widely used to coat mortar protective screens. The electrodeposition of zinc has a relatively lo
Mat. Res.. Publicado em: 19/08/2019
-
6. Use of non-invasive neuromodulation in the treatment of pain in temporomandibular dysfunction: preliminary study
RESUMO JUSTIFICATIVA E OBJETIVOS: Na disfunção temporomandibular, a dor aparece de forma frequente e marcante, com tendência à cronicidade, através de mecanismos de neuroplasticidade mal adaptativo. Diante disso, a estimulação transcraniana por corrente contínua surge como uma possível estratégia de tratamento da dor crônica em disfunção tempor
BrJP. Publicado em: 19/06/2019
-
7. Influence of the anodizing process variables on the acidic properties of anodic alumina films
Abstract In the present work, the effect of the different variables involved in the process of aluminum anodizing on the total surface acidity of the samples obtained was studied. Aluminum foils were treated by the electro-chemical process of anodic anodizing within the following variable ranges: concentration = 1.5-2.5 M; temperature = 303-323 K; voltage =
Braz. J. Chem. Eng.. Publicado em: 2017-10
-
8. DESEMPENHO DO ELETRODO DE FILME DE PALÁDIO NA DETERMINAÇÃO DE TÁLIO E CHUMBO EM AMOSTRAS DE ÁGUAS NATURAIS POR VOLTAMETRIA DE REDISSOLUÇÃO ANÓDICA COM PULSO DIFERENCIAL
The use of a palladium film electrode (PdFE) as an alternative electrode for the determination of thallium (Tl+) and lead (Pb2+) in water samples by anodic stripping voltammetry is proposed. Preliminary studies of the influence of the substrate were performed on the electrochemical behavior of PdFE prepared ex situ. Using a silver solid amalgam electrode as
Quím. Nova. Publicado em: 2017-09
-
9. Evaluation of the anticorrosion performance of peel garlic extract as corrosion inhibitor for ASTM 1020 carbon steel in acidic solution
ABSTRACT Metallic corrosion can be delayed using corrosion inhibitors. However, several industrial corrosion inhibitors are toxic and harmful to the environment and to the human health. In this context, in the last decades, research has been developed to investigate the performance of low toxicity corrosion inhibitors as green inhibitors obtained from vegeta
Matéria (Rio J.). Publicado em: 10/08/2017
-
10. Effect of the modification by titanium dioxide nanotubes with different structures on the fatigue response of Ti grade 2
Nanotechnology is seeing as having potential to raise benefits to several research and application areas. Recently materials with nanostructured surfaces of nanopores, nanotubes and nanowires have become an important investigation field, since their chemical and physical properties may be substantially different from those of the corresponding substrate. In
Mat. Res.. Publicado em: 18/05/2017
-
11. Anodic Oxidation of Sulfide to Sulfate: Effect of the Current Density on the Process Kinetics
The kinetics of the conversion of sulfide to sulfate by electro-oxidation, using a boron-doped diamond (BDD) electrode was studied. Different applied current densities were tested, from 10 to 60 mA cm-2. The results showed that the electrochemical conversion of sulfide to sulfate occurs in steps, via intermediate production of other sulfur species. The oxida
J. Braz. Chem. Soc.. Publicado em: 2017-04
-
12. A Kinetic, Equilibrium, and Thermodynamic Study on the Biosorption of Tl+ and Cd2+ by Eichhornia crassipes Roots Using Carbon Paste Electrode
In this work, Eichhornia crassipes roots were used as a modifier for carbon paste electrode in a biosorption study of thallium (Tl+) and cadmium (Cd2+) ions. The ions were accumulated on modified electrode surfaces at open circuit potential and analyzed by square wave anodic stripping voltammetry. Before the biosorption study, the effect of ratio of biomass
J. Braz. Chem. Soc.. Publicado em: 2016-09