Characterization of the Austenite Reformation Mechanisms as a Function of the Initial Ferritic State in a UNS S32304 Duplex Stainless Steel
AUTOR(ES)
Magalhães, Charles Henrique Xavier Morais, Faria, Geraldo Lúcio de, Lagoeiro, Leonardo Evangelista, Silva, Jéssica Dornelas
FONTE
Mat. Res.
DATA DE PUBLICAÇÃO
17/08/2017
RESUMO
Aiming to better understand the effects of heat treatment parameters on Ferrite-Austenite phase transformation in a 2304 duplex stainless steel different thermal cycles were applied to this steel in a quenching dilatometer. The obtained microstructures were characterized by optical microscopy, transmission electron microscopy and electron backscatter diffraction. It was noticed that the austenite formation mechanism is strongly dependent on initial ferritized state. If the initial structure is completely ferritized, the nitrogen supersaturated solid solution leads to chromium nitrides precipitation and the rate of austenite nucleation decreases. For higher cooling rates, the ferrite grain boundaries control the austenite nucleation rate. The higher the ferrite grain size, the lower the final austenite fraction. If the steel is cooled from a partial ferritized state, the ferrite-austenite phase boundaries work as austenite nucleation site and the austenite growth rate is favored due to the high interfacial energy and the austenitic structures becomes coarser.
Documentos Relacionados
- Martensitic transformation induced by cold deformation of lean duplex stainless steel UNS S32304
- Analysis of the Crystallographic Microtexture of a UNS S32205 and a UNS S32304 Duplex Stainless Steels After Cold Rolling and Heat Treatment
- Tensile properties of duplex UNS S32205 and lean duplex UNS S32304 steels and the influence of short duration 475 ºC aging
- 475 °C Embrittlement in a duplex stainless steel UNS S31803
- Efeitos de envelhecimentos em baixas temperaturas nas propriedades mecânicas e resistência à corrosão dos aços duplex e lean duplex UNS S32205 e UNS S32304