Degradation of resin-dentin bonds of etch-and-rinse adhesive system to primary and permanent teeth
AUTOR(ES)
Lenzi, Tathiane Larissa, Soares, Fabio Zovico Maxnuck, Rocha, Rachel de Oliveira
FONTE
Braz. oral res.
DATA DE PUBLICAÇÃO
27/09/2012
RESUMO
The aim of this in vitro study was to compare the degradation of resin-dentin bonds of an etch-and-rinse adhesive system to primary and permanent teeth. Flat superficial coronal dentin surfaces from 5 primary second molars and 5 permanent third molars were etched with phosphoric acid and bonded with an adhesive system (Adper Single Bond 2, 3M ESPE). Blocks of resin composite (Z250, 3M ESPE) were built up and the teeth sectioned to produce bonded sticks with a 0.8 mm² cross-sectional area. The sticks of each tooth were randomly divided and assigned to be subjected to microtensile testing immediately (24 h) or after aging by water storage (6 months). Data were analyzed by two-way repeated measures ANOVA and Tukey post hoc test (α = 0.05). Failure mode was evaluated using a stereomicroscope (400×). Microtensile values significantly decreased after the 6 months aging, independent of the dentin substrate. In 24 h, the values obtained to primary dentin were lower compared with permanent dentin. This difference was not maintained after aging. Adhesive/mixed failure was predominant in all experimental groups. In conclusion, degradation of resin-dentin bonds of the etch-and-rinse adhesive system occurred after 6 months of water storage; however, the reduction in bond strength values was higher for permanent teeth.
Documentos Relacionados
- Chlorhexidine does not increase immediate bond strength of etch-and-rinse adhesive to caries-affected dentin of primary and permanent teeth
- Effect of green tea extract on bonding durability of an etch-and-rinse adhesive system to caries-affected dentin
- EFEITO DA DOXICICLINA NA RESISTÊNCIA DE UNIÃO À DENTINA DE UM SISTEMA ADESIVO ETCH-AND-RINSE
- Influence of surface moisture condition on the bond strength to dentin of etch-and-rinse adhesive systems
- Bond strength assessment of a universal adhesive system in etch-and-rinse and self-etch modes