Structure and properties of selected cemented carbides and cermets covered with TiN/(Ti,Al,Si)N/TiN coatings obtained by the cathodic arc evaporation process
AUTOR(ES)
Dobrzañski, Leszek A., Golombek, Klaudiusz
FONTE
Materials Research
DATA DE PUBLICAÇÃO
2005-06
RESUMO
This study presents the results of microstructural examinations, mechanical tests and service performance tests carried out on thin TiN/(Ti,Al,Si)N/TiN wear resistance coatings obtained by the CAE process on cermet and cemented carbide substrates. Microstructural examinations of the applied coatings and the substrate were made with an OPTON DSM 940 SEM and a LEICA MEF4A light microscope. Adhesion of the coatings on cemented carbides and cermets was measured using the scratch test. The cutting properties of the materials were determined from service tests in which continuous machining of C45E steel was carried out. The hardness of the substrate and the microhardness of the coatings were determined with a DUH 202 SHIMADZU ultra microhardness tester with a load of 70 mN. Roughness tests were also carried out before applying the coatings and after the PVD process. Cutting tests confirmed the advantages of the TiN/(Ti,Al,Si)N/TiN type coatings obtained using the PVD method in the CAE mode on cemented carbides and cermets, as a material that undergoes very low abrasive, thermal and adhesion wear. These coatings extend tool life compared to commercially available uncoated tools with single and multi-layer coatings deposited using PVD/CVD methods.
Documentos Relacionados
- Study of multilayer coatings of Ti/TiN/TiC produced by pulsed arc discharge
- The correlation between tribological properties of nanostructure TiN coatings and deposition process parameters in PACVD system
- A study of TiAlN coatings prepared by rf co-sputtering
- Mechanical and tribological properties of Ti-containing carbon nanocomposite coatings deposited on TiAlV alloys
- Thick CrN/NbN Multilayer Coating Deposited by Cathodic Arc Technique