Deposition Techniques
Mostrando 1-12 de 176 artigos, teses e dissertações.
-
1. PHOTODEGRADATION OF RhB UNDER VISIBLE LIGHT BY PT/TIO2 NANOPARTICLES PREPARED THROUGH PHOTOREDUCTIVE DEPOSITION PROCESS
Pt/TiO2 nanoparticles were prepared by a simple two-step aqueous solution method, which consists of a low temperature hydrothermal step and a photoreduction deposition step. The as-prepared samples were characterized by XRD, TEM, XPS, UV-vis, and BET techniques. The as-prepared samples exhibited enhanced photocatalytic activity towards the degradation of rho
Quím. Nova. Publicado em: 2021-03
-
2. Recent Developments on the Elucidation of Colloidal Aspects of Asphaltenes and Their Relevance to Oilfield Problems
Asphaltenes constitute the heavy petroleum fraction responsible for deposition events that may lead to reduced oil production, therefore of great interest for flow assurance. These molecules self-assemble in solutions leading to formation of aggregates that eventually grow towards precipitation and blockages in reservoirs and pipelines. Based on the Yen-Mull
J. Braz. Chem. Soc.. Publicado em: 2020-02
-
3. ToF-SIMS Characterization of Nanostructured ZrO2 Coatings Applied to Near Equiatomic Ni-Ti Alloy
The ToF-SIMS technique was applied to analyze thin ZrO2 coatings deposited on the surface of a Ni-Ti alloy. Due to its nanostructured nature, these films are difficult to characterize by conventional techniques. ZrO2 coatings were deposited on near equiatomic Ni-Ti wires by pulse electrodeposition. Part of the samples was electrolytically polished before the
Mat. Res.. Publicado em: 20/12/2019
-
4. Metallic Phthalocyanines: impact of the film deposition method on its supramolecular arrangement and sensor performance
Abstract This short review gives a concise overview of the impact of deposition methods on the supramolecular arrangement of metallic phthalocyanine films and their applications. Primarily, an introduction about the possible phthalocyanine molecular structures and derivatives obtained from modification on the phthalocyanine rings was presented. The possibili
An. Acad. Bras. Ciênc.. Publicado em: 25/11/2019
-
5. PICROSIRIUS RED AND MASSON’S TRICHROME STAINING TECHNIQUES AS TOOLS FOR DETECTION OF COLLAGEN FIBERS IN THE SKIN OF DOGS WITH ENDOCRINE DERMATOPATHOLOGIES
Resumo Endocrinopatias caninas como hipotireoidismo e o hiperadrenocortismo causam alterações dermatológicas características. As fibras de colágeno desempenham um papel vital na manutenção da integridade estrutural e também na determinação da função dos tecidos. O objetivo deste estudo foi avaliar as colorações de picrosirius red sob polarizaç
Ciênc. anim. bras.. Publicado em: 24/10/2019
-
6. Assessing Water Erosion Processes in Degraded Area Using Unmanned Aerial Vehicle Imagery
ABSTRACT The use of Unmanned Aerial Vehicles (UAVs) and Structure from Motion (SfM) techniques can contribute to increase the accessibility, accuracy, and resolution of Digital Elevation Models (DEMs) used for soil erosion monitoring. This study aimed to evaluate the use of four DEMs obtained over a year to monitor erosion processes in an erosion-degraded ar
Rev. Bras. Ciênc. Solo. Publicado em: 14/10/2019
-
7. Investigation of the effect of nozzle design on rheological bioprinting properties using computational fluid dynamics
ABSTRACT Bioprinting is the utilization of techniques derived from three-dimensional printing to generate complex biological structures which may replace natural tissues or organs. It employs high spatial resolution deposition of different cell types, growth factors and biomaterials. Those together form bioinks, which are the bioprinting inputs, analogously
Matéria (Rio J.). Publicado em: 16/09/2019
-
8. ESTIMATING VEGETATION VOLUME OF COFFEE CROPS USING IMAGES FROM UNMANNED AERIAL VEHICLES
ABSTRACT Tree crops, such as Arabica coffee (Coffea arabica L.), present enormous technical challenges in terms of pesticide application. The correct deposition and distribution of the active ingredient throughout the aerial part of these plants depends on knowledge of the canopy volume, but manually determining this volume is time consuming and imprecise. T
Eng. Agríc.. Publicado em: 09/09/2019
-
9. Glycerol Effect on the Corrosion Resistance and Electrodeposition Conditions in a Zinc Electroplating Process
Zinc electrodeposition is an economical process of Zn coating compared to conventional galvanic process. The galvanizing process is used in various industrial sectors to protect ferrous alloys during the corrosion process. In buildings, the galvanizing process is widely used to coat mortar protective screens. The electrodeposition of zinc has a relatively lo
Mat. Res.. Publicado em: 19/08/2019
-
10. Impact of methods used to reconstitute tailings specimens on the liquefaction potential assessment of tailings dams
Abstract The aim of this research is to investigate the liquefaction susceptibility of silt sandy mining tailings by experimental laboratory techniques. The main aspect analyzed is how techniques of sample reconstitution impact the results obtained in static undrained triaxial tests. Different methods of sample preparation are reviewed, such as moist tamping
REM, Int. Eng. J.. Publicado em: 19/06/2019
-
11. Análise das Propriedades Mecânicas de Juntas de Aço Carbono Estrutural Soldadas pelo Processo Arco Submerso com os Arcos Simples e Duplo (Tandem-Arc)
Resumo Diante de um cenário econômico onde a concorrência é cada vez mais acirrada, a busca por processos, técnicas e equipamentos de soldagem que proporcionem ganhos na produtividade é uma exigência para garantir a competitividade das empresas no mercado. Com o desenvolvimento e a adoção de novas tecnologias é possível inovar os processos convenc
Soldag. insp.. Publicado em: 13/06/2019
-
12. Additive Techniques to Refurbish Ni Based Components
Abstract The attractiveness of additive techniques to refurbish worn components requires the availability of data from different process. This study correlates two additive techniques, Plasma Transferred Arc (PTA – AM) and Direct Laser Deposition (DLD), using IN 625 wire. Specific features of each technique are discussed regarding their potential use to re
Soldag. insp.. Publicado em: 09/05/2019