Ferro Fundido Nodular Perlitico
Mostrando 1-4 de 4 artigos, teses e dissertações.
-
1. Avaliação da tenacidade à fratura em ferro fundido nodular austemperado classe 65-45-12
O objetivo deste trabalho foi avaliar o desempenho de três condições de austêmpera para uma liga de ferro fundido nodular 65-45-12 austêmperada, em relação à tenacidade à fratura (KIC), correlacionando às propriedades mecânicas e metalúrgicas obtidas em cada condição de tratamento térmico ensaiadas. Para tanto, foi necessário a confecção de
Publicado em: 2011
-
2. Furação de ferros fundidos austemperados e nodular perlítico / Machinability of Austempered Ductile Irons and Pearlitic Ductile Iron in Drilling Process
Many materials have mechanical proprieties improved by heat treatments, but this can cause changes in the structure of the material, worsening its machinability, as in the case of austempered ductile iron (ADI) that despite of presenting better mechanical proprieties it has lower machinability when compared with the conventional ductile iron and steel of sim
Publicado em: 2009
-
3. CORRELAÇÃO ENTRE MICROESTRUTURA E VIDA-FADIGA EM FERROS FUNDIDOS NODULARES / CORRELATION BETWEEN MICROSTRUCTURE AND FATIGUE LIFE IN NODULAR CAST IRONS
Esta pesquisa teve como objetivo avaliar a vida-fadiga de dois ferros fundidos nodulares modificados metalurgicamente, sendo uma classe predominantemente ferrítica e outra.perlítica. Inicialmente, amostra dos dois ferros fundidos nodulares ferrítico e perlítico foram fundidas adotando-se moldação em areia na geometria padrão Y-block. Em seqüência, c
Publicado em: 2004
-
4. The effect of surface rolling on fatigue behavior in a pearlitic ductile cast iron / "Influência do roleteamento no comportamento em fadiga de um ferro fundido nodular perlítico"
Surface rolling is a mechanical treatment commonly used in parts fabricated with steel and ductile cast iron, specifically in stress concentration regions, to improve fatigue properties. This process hardens and introduces compressive residual stresses to the surface of the material through the application of controlled strains, thus provoking a reduction of
Publicado em: 2002