Insulators
Mostrando 1-12 de 96 artigos, teses e dissertações.
-
1. Economic viability of a thermal blanket produced from asphalt waste used in roof covering
RESUMO Este trabalho apresenta os resultados obtidos em um projeto de construção civil, no qual se dimensiona a isolação térmica do telhado de uma pousada na região de São Joaquim, SC, considerada uma das regiões mais frias do Brasil. Propôs-se o uso de um isolante produzido à base de asfalto reciclado, apontando sua eficiência de isolação térm
Matéria (Rio J.). Publicado em: 25/11/2019
-
2. Characterization of Algerian kaolins for utilization as a raw material in electrical insulators
Resumo O objetivo desta investigação foi caracterizar três amostras de caulim (DD1, DD2 e DD3) coletadas do depósito de Djebel Debbagh (leste da Argélia) para serem utilizadas em isoladores elétricos de porcelana. Análise granulométrica, fluorescência de raios X, difração de raios X, microscopia eletrônica de varredura e análise térmica (TG-ATD
Cerâmica. Publicado em: 06/06/2019
-
3. An Amorphous Silicon Photo TFT with Si3N4/Al2O3 or HfO2 Double Layered Insulator for Digital Imaging Applications
Abstract This paper focuses on amorphous silicon photo thin-film transistors with double layered insulator using Si3N4/Al2O3 or HfO2 as candidates for the succession of Si3N4 as a traditional insulator in the fabrication of hydrogenated amorphous silicon thin-film transistors. Whether for industry or for research, there is a need to investigate the use of th
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2019-03
-
4. Changes in the crystalline degree in neutron irradiated EPDM viewed through infrared spectroscopy and inelastic neutron scattering
ABSTRACT The changes in the degree of crystallinity in commercial Ethylene Propylene Diene rubber-type M (EPDM) irradiated with neutrons at different doses has been studied by means of inelastic neutron scattering and infrared absorption spectroscopy experiments. EPDM samples were taken from the housing of non-ceramic electrical insulators which are used in
Matéria (Rio J.). Publicado em: 19/07/2018
-
5. Thermal Insulating Foams Produced From Glass Waste and Banana Leaves
Abstract In this work, compositions containing transparent glass bottles and banana leaves (desiccated and crushed), with different mass fractions (30-50%), were prepared for obtaining cellular materials for thermal insulation purposes. The formulated and prepared compositions were uniaxially pressed (10 MPa) and the compact powders fired between 700 and 850
Mat. Res.. Publicado em: 11/08/2016
-
6. Photoacoustic Thermal Characterization of Banana Fibers
Natural fibers are attracting the interest of engineering sectors owing to specific advantages such as lightweight and lower cost as well as an inherent condition of being renewable, biodegradable, recyclable and environmentally correct with respect to CO2 emission. In addition, several natural fibers present mechanical and thermal properties appropriate for
Mat. Res.. Publicado em: 2015-12
-
7. Nanostructured Titanium Film Deposited by Pulsed Plasma Magnetron Sputtering (Pdms) on a High Voltage Ceramic Insulator for Outdoor Use
In this study, the cold plasma technique was used to produce nanometric titanium films with hydrophobic and anti-fouling properties. The films where deposited on porcelain electrical insulators surfaces to minimize the effects of leakage current. The magnetron sputtering technique was used with a target of pure titanium sheet, and argon as the ionization gas
Mat. Res.. Publicado em: 2015-08
-
8. Hydrophobicity Classification of Polymeric Insulators Based on Embedded Methods
Hydrophobicity is an important parameter to characterize electrical properties of insulated materials. Therefore, it is an urgent task to develop on-line instruments to identify the hydrophobicity of insulated material's surface conveniently, quickly and accurately. For this purpose, a novel evaluation system with image processing and decision tree is propos
Mat. Res.. Publicado em: 2015-02
-
9. Comparison of polymers and ceramics in new and discarded electrical insulators: reuse and recycling possibilities
The expansion and maintenance of electricity distribution networks generates large amounts of waste, much of it in the form of discarded insulators that are not reused or recycled. This paper describes the results of tests on used and new ceramic and polymeric insulators to verify if their exposure to weathering justifies their replacement. In new and used c
Matéria (Rio J.). Publicado em: 2013-12
-
10. Algumas contribuições ao estudo do Grafeno e dos Isolantes Topológicos / Some contributions to study of graphene and topological insulators
Nesta tese são estudados grafeno e isolantes topológicos. No caso do grafeno é considerado o espalhamento das quase partículas por defeitos topológicos representados por buracos, pentágonos e heptágonos. No caso de buracos os desvios de fase da função de onda são obtidos e em baixas concentrações são irrelevantes para o transporte eletrônico, d
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 13/02/2012
-
11. Evaluation of the properties of iron oxide-filled castor oil polyurethane
The aim of this study was to obtain and evaluate the electrical, thermal and mechanical properties of iron oxide-filled castor oil polyurethane (PU/Fe2O3). The iron oxide used in this study was a residue derived from the steel pickling process of a Brazilian steel rolling industry. Polymeric composites with different iron oxide volume fractions (2.5, 5.0, 7.
Mat. Res.. Publicado em: 26/10/2012
-
12. Classification of polymers insulators hydrophobicity basead on digital image processing
Although the hydrophobicity is usually an arduous parameter to be determined in the field, it has been pointed out as a good option to monitor aging of polymeric outdoor insulators. Concerning this purpose, digital image processing of photos taken from wet insulators has been the main technique nowadays. However, important challenges on this technique still
Materials Research. Publicado em: 27/03/2012