Lithium Batteries
Mostrando 1-12 de 36 artigos, teses e dissertações.
-
1. Review of Power Device for Solar-Powered Aircraft Applications
ABSTRACT This paper reviews various power device components of solar-powered aircraft such as photovoltaic (PV) cells, maximum power point tracker (MPPT) and rechargeable batteries. The various power device components were highlighted, and the ones applicable to aircraft were analyzed, based on criteria as efficiency for photovoltaic cells; energy densities
J. Aerosp. Technol. Manag.. Publicado em: 10/10/2019
-
2. Mathematical Modeling and Parameter Estimation of Battery Lifetime using a Combined Electrical Model and a Genetic Algorithm
RESUMO Neste artigo é proposta uma metodologia baseada na meta-heurística Algoritmo Genético para estimar os parâmetros no modelo Chen e Rincón-Mora, sendo este aplicado na modelagem matemática do tempo de vida de baterias de Lítio-íon Polímero. O modelo também é parametrizado a partir da metodologia convencional, que necessita de dados obtidos po
TEMA (São Carlos). Publicado em: 06/06/2019
-
3. PAni-coated LiFePO4 Synthesized by a Low Temperature Solvothermal Method
The composite LiFePO4/polyaniline was prepared by chemical synthesis to promote the intensification of the electrochemical properties for use as cathodes in lithium ion batteries. The X-ray diffraction (XRD) of LiFePO4 synthesized by solvothermal method were indexed to the orthorhombic structure, according to the JCPDS 40-1499. The spectra Raman and FTIR sho
Mat. Res.. Publicado em: 03/12/2018
-
4. Commitment Between Roughness and Crystallite Size in the Vanadium Oxide Thin Film opto-electrochemical Properties
The V2O5 thin films has been widely studied because it has application as ionic host in electrochromic and lithium-ion batteries, two technologies that have an intimate connection with sustainability as substitutes for fossil energies and as agents for improving energy efficiency. In electrochromic technology, V2O5 is applied as a passive electrode due to it
Mat. Res.. Publicado em: 01/11/2018
-
5. Hot Pressing of Electrospun PVdF-CTFE Membranes as Separators for Lithium Batteries: a Delicate Balance Between Mechanical Properties and Retention
A systematic investigation of the effect of hot-pressing on polyvinylidene fluoride (PVdF) - chlorotrifluoroethylene (CTFE) electrospun membranes, intended as separators and substrate for the electrolyte of lithium batteries, has been carried out by means of dynamic mechanical analysis. Absorption and desorption gravimetric measurements and infrared spectros
Mat. Res.. Publicado em: 11/10/2018
-
6. LIXIVIAÇÃO ÁCIDA DE BATERIAS ÍON-LÍTIO
This paper describes a route for recovering cobalt and lithium from spent Li-ion batteries via acidic leaching. Sulfuric, hydrochloric, hydrofluoric and formic acids were used as leachants. Hydrogen peroxide was added as reductant, except for formic acid since it is itself a reductant. Experiments were run at 25-40 ºC for 1-3 h. Under the best optimal condi
Quím. Nova. Publicado em: 2018-05
-
7. Synthesis and Characterization of LiCoO2 from Different Precursors by Sol-Gel Method
Lithium cobalt oxide, LiCoO2, widely used as cathode in lithium ion batteries was synthesized and their structural and electronic properties investigated. The crystalline powders were prepared by the sol-gel method with four complexing agents: citric acid, glycine, starch and gelatin. These syntheses were compared with the blank test (without complexing agen
J. Braz. Chem. Soc.. Publicado em: 2017-11
-
8. Green Energy Generation Using FLC Based WECS With Lithium Ion Polymer Batteries
ABSTRACT Green Energy Generation Using Wind energy conversion system is achieved using Lithium Ion Polymer Batteries and Fuzzy logic controller. Presented scheme also provides the constant output power for the stand alone loads like Island, Hills Stations, Ships and Remote locations etc. A fuzzy-logic controller based Wind energy conversion system with perma
Braz. arch. biol. technol.. Publicado em: 23/01/2017
-
9. Electrochemical Investigations of Li2Fe0.8-xMn0.2MxSiO4 (M = Mg2+, Zn2+) Cathodes for Lithium Ion Batteries
The Mn2+ and Mg2+ (or Zn2+) co-doped Li2Fe0.8-xMn0.2MxSiO4 (x = 0.05 and 0.1) are synthesized by a solid-state reaction route. Compared with the single doped Li2Fe0.8Mn0.2SiO4, the co-doped samples show improved cycling performance. The capacity retention can stay above 50% after 50 cycles, which is significantly higher than 30.4% for Li2Fe0.8Mn0.2SiO4. This
J. Braz. Chem. Soc.. Publicado em: 2016-11
-
10. Fabrication of Cathode Materials Based on Limn2o4/Cnt and Lini0.5mn1.5o4/Cnt Nanocomposites for Lithium – Ion Batteries Application
AbstractCarbon nanotubes (CNTs) are a promising candidate material for use in lithium batteries due to 1D tubular structure, high electrical, thermal conductivities, and extremely large surface area. In this work, the MWCNTs were purified by dispersion in a mixture of HNO3 and H2SO4acids. The oxidized-MWCNTs were used as conducting addition to prepare a nano
Mat. Res.. Publicado em: 2015-10
-
11. Microwave-assisted hydrothermal synthesis of magnetite nanoparticles with potential use as anode in lithium ion batteries
Rechargeable solid-state batteries have long been considered an attractive power source for a wide variety of applications, and in particular, lithium-ion batteries are emerging as the technology of choice for portable electronics. One of the main challenges in the design of these batteries is to ensure that the electrodes maintain their integrity over many
Mat. Res.. Publicado em: 09/09/2014
-
12. Synthesis of Co-Al-Cl LDH by cathodic material reprocessing from cellular phone batteries
The aim of this paper was the recovering of the cathodic material from discarded lithium ion batteries for obtainment of the lamellar double hydroxides (LDHs) by the co-precipitation method at variable pH in HCl and H2O2 1:1 (v/v) acid solution containing Co and Al (extracted from cathodic material composed of LiCoO2 and aluminum foil). These metals were pre
Mat. Res.. Publicado em: 29/04/2014