Phase Forming
Mostrando 1-12 de 426 artigos, teses e dissertações.
-
1. COMPREENDENDO OS MECANISMOS DE CORROSÃO DE LIGAS DE AL-CU-LI: UMA INVESTIGAÇÃO ATRAVÉS DE TÉCNICAS ELETROQUÍMICAS GLOBAIS E LOCAIS
In this study, the corrosion mechanism of an Al-Cu-Li alloy manufactured by two different treatment routes (T3 and T851) was evaluated by immersion and electrochemical tests in solutions containing chloride ions (Cl-). For both alloys, the formation of cavities on the surface was associated with micrometer-sized intermetallics (IM’s), however, in addition
Química Nova. Publicado em: 2022
-
2. IN SITU DRIFTS/MS STUDIES ON THE INTERACTION OF METHANOL AND ETHYL ACETATE OVER MG-LA CATALYST
The surface intermediates formed on the Mg-La catalyst (molar ratio 1:1) were studied through temperature-programmed desorption (TPD) and diffuse reflectance infrared Fourier transform spectroscopy coupled to mass spectrometry (DRIFTS-MS) using methanol (MeOH) and ethyl acetate (EA) as probe molecules. TPD results showed that the products formed from adsorbe
Quím. Nova. Publicado em: 2020-09
-
3. Structural Study of Phenolic Acids by Triple Quadrupole Mass Spectrometry with Electrospray Ionization in Negative Mode and H/D Isotopic Exchange
This work reports the theoretical and experimental study of fragmentation reactions in the gas phase of five phenolic acids using triple quadrupole mass spectrometry by electrospray ionization in negative ionic mode, as well as the isotope exchange experiments. MS/MS spectra were analyzed to suggest the fragmentation mechanisms, while theoretical calculation
J. Braz. Chem. Soc.. Publicado em: 2020-02
-
4. The Effects of Friction Coefficient on Formability Behaviour of Dual Phase Steel
The effects of friction coefficient on formability behavior of advanced high-strength steel sheets have been examined in this study. For this purpose, forming analysis has been conducted by stretching the three different steel sheets such as DP600, DP800 and DP1000. Forming processes have been done by using punch that has different friction coefficients (0.0
Mat. Res.. Publicado em: 14/11/2019
-
5. Efeito dos ácidos itacônico e fumárico na copolimerização em emulsão do estireno com acrilato de n-butila para produção de argamassa cimentícia
RESUMO Monômeros carboxílicos são frequentemente empregados em formulações de polímeros obtidos via polimerização em emulsão e miniemulsão visando melhorar ás propriedades de aplicação dos látexes. O objetivo deste trabalho foi avaliar o efeito dos ácidos itacônico IAI), fumárico (AF) e metacrílico (AMA) na copolimerização em emulsão do
Matéria (Rio J.). Publicado em: 16/09/2019
-
6. Environmental enrichment reduces brain excitability in adult rats overnourished during lactation
RESUMO Objetivo: Este estudo analisou se a exposição ao ambiente enriquecido durante a fase juvenil da vida interferiria na atividade elétrica do cérebro de ratos adultos. Além disso, a presente pesquisa também investigou se esse provável efeito na atividade elétrica cerebral poderia ser afetado pela hipernutrição durante a lactação. A eletrofis
Arq. Neuro-Psiquiatr.. Publicado em: 05/09/2019
-
7. Physicochemical and microbiological dynamics of the fermentation of the ccn51 cocoa material in three maturity stages
Resumo A dinâmica físico-química e microbiológica durante a fase de fermentação do material de cacau CCN51 foi avaliada em três fases de maturidade (fase 2: 130-152 dias após a antese DDA, fase 3: 153-174 DDA e Fase 4: 175 -196 DDA). Através da técnica da microfermentación foi monitorizado a cada 24h as variáveis físico-químicas (pH, acidez ti
Rev. Bras. Frutic.. Publicado em: 19/06/2019
-
8. Study of ZnAl2O4 spinel nanoparticles synthesized using gelatin as organic precursor
Resumo Neste trabalho, pós do espinélio aluminato de zinco foram preparados por um método Pechini modificado, rápido, simples, ambientamento seguro e de baixo custo, utilizando gelatina comercial como precursor orgânico. Os materiais foram calcinados a 600, 700 e 800 °C e caracterizados por análise termogravimétrica, difratometria de raios X (DRX) in
Cerâmica. Publicado em: 06/06/2019
-
9. Avaliação da atividade antimicrobiana e adsortividade de nanopartículas de sílica dopadas com CuO
RESUMO Nanomateriais exibem propriedades que se aplicam nas mais variadas áreas, entre estas, na área da saúde e agrícola, nas quais as pesquisas vêm aumentando progressivamente. Neste trabalho sintetizamos nanopartículas de sílica não porosas dopadas com óxido de cobre (CuO) usando método de Stöber com pequenas modificações. Em adição, a ativ
Matéria (Rio J.). Publicado em: 20/05/2019
-
10. Rheological properties of low-density polyethylene filled with hydrophobic Co(Ni)-Al layered double hydroxides
Abstract Cobalt/aluminum and nickel/aluminum layered double hydroxide (LDH - M+2:Al molar ratio of 3:1) were intercalated with dodecylsulphate (DDS), laurate (LAU), stearate (STE) and palmitate (PAL) and used as filler in low-density polyethylene (LDPE) in percentages between 0.2 and 7.0wt%. After injection molding, the samples were submitted to morphologic
Polímeros. Publicado em: 01/04/2019
-
11. METODOLOGIA PARA DETECÇÃO ELETROQUÍMICA QUALITATIVA DE COMPOSTOS ORGÂNICOS EM INTERFACES PETRÓLEO/ÁGUA
The possibility of detecting some organic compounds directly in a petroleum/water interface was described. Aqueous phase was composed by 1 x 10-3 mol L-1 NaCl solution and the oil phase was carried out using crude oil forming an oil/water interface. Carbon based screen-printed electrodes was used in conjunction with square-wave voltammetry technique, constit
Quím. Nova. Publicado em: 2019-01
-
12. Influence of High Current-Density Impulses on the Stress-Strain Response and Microstructural Evolution of the Single Crystal Superalloy CMSX-4
Owing to the low formability of single-crystal nickel-based materials, single-crystal components are typically cast. Subsequently, a multi-stage heat treatment is carried out in order to partially compensate the dendrite segregation and to stabilize the precipitated γ’-phase. Such components possess a high resistance to creep at elevated temperatures. Sin
Mat. Res.. Publicado em: 22/10/2018