Stoichiometric Combustion
Mostrando 1-9 de 9 artigos, teses e dissertações.
-
1. Impact of fuel quantity on luminescence properties of Sr3Al2O6:Eu by combustion synthesis
Abstract The photoluminescent behavior of Eu-doped Sr3Al2O6 obtained by highly efficient solution combustion synthesis is reported. In order to understand the influence of the fuel on the synthesis, the stoichiometric quantity and an excess of fuel were evaluated. By adjusting the amount of fuel, different luminescence responses were obtained, allowing europ
Cerâmica. Publicado em: 2023
-
2. Obtención de nanopartículas de LiCoO2 mediante síntesis por combustión de soluciones
ABSTRACT Lithium Cobalt Oxide (LiCoO2) nanoparticles were obtained by the Solutions Combustion Synthesis method, using starch as fuel. Four starch/nitrates ratios (φe) (ranging 0.5-1.25) have been studied. One route was a conventional, stoichiometric process, while the other ones were a nonstoichiometric process. The samples were calcined in air at 773K. Th
Matéria (Rio J.). Publicado em: 19/07/2018
-
3. Effect of Urea Excess on the Properties of the MgAl2O4 Obtained by Microwave-Assisted Combustion
In this paper, magnesium aluminate spinels were prepared by microwave-assisted combustion, using urea as fuel. In order to evaluate the effect of the urea excess used in the synthesis, its mass was added in a range of 1.0 to 2.5 times the stoichiometric amount required. The materials produced were characterized by TGA, FTIR, XRF, XRD, BET, SEM and TEM. The r
Mat. Res.. Publicado em: 23/10/2017
-
4. Analysis of combustion efficiency in a pelletizing furnace
Abstract The objective of this research is to assess how much the improvement in the combustion reaction efficiency can reduce fuel consumption, maintaining the same thermal energy rate provided by the reaction in a pelletizing furnace. The furnace for pelletizing iron ore is a complex thermal machine, in terms of energy balance. It contains recirculation fa
REM, Int. Eng. J.. Publicado em: 2016-09
-
5. Microwave Assisted Combustion Synthesis and Characterization of Nanocrystalline Nickel-doped Cobalt Ferrites
Abstract Nanoparticles nickel-doped cobalt ferrites [NixCo1-xFe2O4 (x = 0.0, 0.25, 0.50, 0.75 and 1.0 of Ni2+)] were prepared by the microwave combustion synthesis, using a stoichiometric mixture of metal nitrates and urea as the oxidizer and fuel to drive the reaction. The effect of microwave irradiation on the phase composition was favorable to promote the
Mat. Res.. Publicado em: 01/08/2016
-
6. Combustion synthesis of Co-Cu-Mn oxides deploying different fuels
ABSTRACTTernary spinel-like oxides such as CuFeMnO4, CoCuMnOxand CuCr2O4 are attractive materials due to their absorbent properties when used as pigments for selective surfaces thus improving solar heaters efficiency. These materials are obtained through sol-gel and sol-gel-combustion methods. This work proposes the synthesis of mixed oxides of Co, Cu and Mn
Matéria (Rio J.). Publicado em: 2015-09
-
7. Análise do comportamento de uma turbina a gás operando com combustão enriquecida com oxigênio / Analysis of the behavior of a gas turbine working with oxygen-enhanced combustion
O presente trabalho tem por objetivo a análise do comportamento de uma turbina a gás utili-zando combustão enriquecida com oxigênio (em inglês OEC – Oxygen-Enhanced Combusti-on) até a proporção de 30% de oxigênio no oxidante. A metodologia utilizada é uma modela-gem numérica da turbina, considerando o processo de combustão e consequente altera�
Publicado em: 2011
-
8. Controle simultâneo de temperatura e estequiometria aplicado em um secador vertical de revestimentos cerâmicos alimentado com gás natural / Simultaneous control of temperature and stoichiometric applied to a vertical dryer ceramic feeded with natural gas
Este trabalho descreve o desenvolvimento de um protótipo para o controle em malha fechada da temperatura e estequiometria de um secador vertical cerâmico alimentado a gás natural, instalado na linha de produção de revestimentos cerâmicos da empresa Eliane Revestimentos Cerâmicos - Unidade II, em Cocal do Sul - SC. É apresentada a fundamentação teó
Publicado em: 2009
-
9. Desenvolvimento do precesso de reduÃÃo de Ãcido nitroso por Ãcido amino sulfÃmico. Modelagem cinÃtica associada à transferÃncia gÃs-lÃquido
The combustion of organic products, in particular, the natural gas, leads to the generation of nitrogenated oxides (NOx = NO and NO2; N2O) from both sources, the nitrogenous originated from the combustion air and nitrogenated compounds present in the fuel. NOx emissions can damage the human health and environment. They have been contributing widely to the fo
Publicado em: 2003