Thermal Annealed
Mostrando 1-12 de 31 artigos, teses e dissertações.
-
1. The Influence of Microstructure and Mechanical Resistance on the Shape Memory of Ecae Processed Stainless Fe-Mn-Si-Cr-Ni-Co Steel
In the current work, XRD, SEM, EBSD and TEM techniques were used to evaluate the microstructure of stainless Fe-Mn-Si-Cr-Ni-Co shape memory steel processed by ECAE and annealed for one hour at temperatures ranging from 650ºC to 950ºC. The results were then correlated with the mechanical and shape-memory properties of the steel. It was observed that the sam
Mat. Res.. Publicado em: 09/08/2018
-
2. Impact of Alloy Composition and Thermal Stabilization on Martensitic Phase Transformation Structures in CuAlMn Shape Memory Alloys
Alloys of CuAlMn are known as cheap, high strength shape memory alloys with an excellent damping capacity within their austenitic-martensitic phase transformation, compared to alloy systems like NiTi, CuZnAl or MnCu. But CuAlMn alloys have disadvantage due to generation of voids by a high shrinkage which further increases the existing proneness to stress cra
Mat. Res.. Publicado em: 19/07/2018
-
3. Structural, Thermal, Optical, and Photoacoustic Study of Mechanically Alloyed Nanocrystalline SnTe
A nanostructured SnTe phase was produced by mechanical alloying after 2 h of milling. Part of the as-milled powder was annealed and its X-ray diffraction (XRD) pattern was recorded. The XRD patterns of the as-milled and annealed samples were refined using the Rietveld method. After annealing, partial decomposition of the SnTe phase was observed and corrobora
Mat. Res.. Publicado em: 07/06/2018
-
4. Influence of Nanoxides on Diffusivity and Solubility of Hydrogen in Pd-based alloys
The hydrogen interaction in palladium alloys with addition of Ce, Zr and Y was studied. These alloys are produced by arc-melting and then cold rolled into thin foils. Heat treatment at 800ºC for 24h in air atmosphere is applied to induce internal oxidation. Hydrogen permeation tests and TDS (Thermal Desorption Spectroscopy) are carried out to evaluate hydro
Mat. Res.. Publicado em: 11/01/2018
-
5. Examining the Thermal Stability of an Al-Mg-Sc Alloy Processed by High-Pressure Torsion
An Al-3%Mg-0.2%Sc alloy was solution treated and subjected to 10 turns of high-pressure torsion (HPT). Thereafter, the HPT-processed material was annealed for 1 hour at temperatures ranging from 423 to 773 K and its mechanical properties and microstructural evolution were examined using microhardness measurements and EBSD analysis. The results demonstrate th
Mat. Res.. Publicado em: 23/10/2017
-
6. Synthesis and Characterization of Nb2O5:La3+,Eu3+ Phosphors Obtained by the Non-Hydrolytic Sol-Gel Process
The phosphor-converted light-emitting diode technique is an important solid-state illumination strategy. Sulfide-based materials are the most often employed red phosphors, but they are chemically unstable and present lower efficiency in comparison to the blue and green phosphors. Therefore, it is important to find a new red phosphor source that can emit inte
J. Braz. Chem. Soc.. Publicado em: 2015-12
-
7. Comparative Study of Magnetic Properties and Microstructure for As-cast and Square-wave Pulse Current Joule Annealed Wires
We here report on a comparative study of the microstructure and magnetic properties of as-cast and SPCJA-ed Co-based wires for potential sensor applications. Experimental results indicate that both as-cast and SPCJA-ed wires exhibit typical amorphous feature. There also exists the enhanced local ordering degree of atomic arrangement and obvious transformatio
Mat. Res.. Publicado em: 23/10/2015
-
8. Heterojunction between Al2O3 and SnO2 thin films for application in transparent FET
Alternative materials for use in electronic devices have grown interest in the past recent years. In this paper, the heterojunction SnO2/Al2O3 is tested concerning its use as a transparent insulating layer for use in FETs. The alumina layer is obtained by thermal annealing of metallic Al layer, deposited by resistive evaporation technique. Combination of und
Mat. Res.. Publicado em: 09/09/2014
-
9. Magnetostriction in ar/sup +/ implanted and annealed co/pd multilayers
Magnetostriction curves with (111) textured polycrystalline Co/Pd multilayers, as deposited or submitted to ArS ion implantation or thermal annealing, are presented and discussed. Both treatments, while promoting intermixing among CO and Pd atoms, induce an increase in the saturation magnetostriction values. The evolution of the engineering curves, however,
Publicado em: 2011
-
10. Síntese e caracterização de filmes à base de Si e Ge dopados com espécies magnéticas / Synthesis and characterization of Si and Ge based films doped with magnetic species
Along the last few years, the doping of semiconductors (either II-VI, IV-VI, III-V, and group-IV compounds) with magnetic species have been extensively studied due to their potential applications in spintronics. Among them, Si- and Ge-based magnetic semiconductors are very attractive because of their total compatibility with the well-established current semi
Publicado em: 2010
-
11. OrientaÃÃo de anticorpos em alumÃnio empregando monocamadas auto-organizadas para produÃÃo de microssensores capacitativos
There is a growing demand for in situ monitoring of antigen-antibody interaction. Immunosensors based on antigenâantibody interaction have attracted great interest in recent years in various areas. Numerous techniques such as optical, mass-sensitive and electrochemical have been employed for this purpose. Among the electrochemical techniques, a capacitive m
Publicado em: 2007
-
12. Obtenção de fritas vitrocerâmicas a partir de resíduos sólidos industriais / Glassceramics frits attainment from industrial solid wastes
This work studies the residue obtained from the process of aluminum metal extraction activities, a great interest process, because of Brazil own some of the biggest bauxite mineral reserves in all the world. As a useful choice for no residue generation, and a support for environmentally friendly technologies, this work studies the white dross residue (WDR),
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 15/09/2006