Torsion Test
Mostrando 1-12 de 39 artigos, teses e dissertações.
-
1. Torsional fatigue strength of reciprocating and rotary pathfinding instruments manufactured from different NiTi alloys
Abstract To evaluate the torsional properties of engine-driven pathfinding instruments manufactured from different NiTi alloys – R-Pilot (tip size 12.5;.04 taper; M-Wire) and One G (tip size 14;.03 taper; Conventional NiTi). A total of 40 NiTi instruments from engine-driven pathfinding instruments (n = 20) were used. The torsion tests followed ISO 3630-1 (
Braz. oral res.. Publicado em: 28/10/2019
-
2. Torsional comparative biomechanical test of modified tibial-plateau-leveling osteotomy plate and locking plate in canine synthetic tíbias
RESUMO O objetivo do presente estudo foi desenvolver placa de TPLO bloqueada modificada e avaliar, em ensaio de torção, a estabilização óssea proporcionada pelo implante desenvolvido comparativamente a método de fixação óssea convencional com placa reta bloqueada. As variáveis obtidas foram força máxima, ângulo no pico de torque e rigidez. Foram
Arq. Bras. Med. Vet. Zootec.. Publicado em: 28/10/2019
-
3. Behaviour of hollow circular section with multiple perforations under compression, flexure and torsion
Abstract Effect of the presence of perforations on thin structure has been extensively investigated for decades. Various perforation parameters were investigated in past studies. However, study on thin cylinder with multiple perforations has not been carried out. In searching for lighter structural members, the concept of perforated hollow section has been i
Lat. Am. j. solids struct.. Publicado em: 14/03/2019
-
4. Calibration and evaluation of the Lemaitre damage model using axial- torsion fatigue tests on five engineering alloys
Abstract The Lemaitre damage model is evaluated using fatigue test data from five engineering alloys: 1045 steel, 16MnR steel, 7075-T651 Al alloy, extruded AZ61A Mg alloy, and extruded AZ31B Mg alloy. Tension-compression, torsion, proportional axial-torsion, and 90° out-of-phase axial-torsion loadings were investigated. The results show that the overall acc
Lat. Am. j. solids struct.. Publicado em: 22/10/2018
-
5. Tonic Investigation Concept of Cervico-vestibular Muscle Afferents
Abstract Introduction Interdisciplinary research has contributed greatly to an improved understanding of the vestibular system. To date, however, very little research has focused on the vestibular system's somatosensory afferents. To ensure the diagnostic quality of vestibular somatosensory afferent data, especially the extra cranial afferents, stimulation
Int. Arch. Otorhinolaryngol.. Publicado em: 2017-03
-
6. Biomechanical Analysis of Locking Reconstruction Plate Using Mono- or Bicortical Screws
This experimental in vitro study evaluated the influence of screw length on the mechanical properties of a locking reconstruction plate designed with locking rings inserted into plate holes. Synthetic bone cylinders with 10 mm fracture gap and seven-hole locking reconstruction plates were used. Two groups of bone-plate constructs were assembled: Group 1 –
Mat. Res.. Publicado em: 08/04/2016
-
7. The Video Head Impulse Test in a Case of Suspected Bilateral Loss of Vestibular Function
Introduction A patient who had no symptoms suggestive of bilateral loss of vestibular function presented no responses in rotational and caloric tests. Objectives To demonstrate the importance of the video head impulse test in neurootologic diagnosis. Resumed Report This patient had a neuro-otologic evaluation and presented no responses in torsion swing
Int. Arch. Otorhinolaryngol.. Publicado em: 2016-03
-
8. The impact of tibial torsion measurements on gait analysis kinematics
Objective: To measure and compare tibial torsion values as assessed by goniometry and three-dimensional kinematics. In addition, the impact of each one of these measurements on kinematic and kinetic results for normal gait was determined. Methods: Twenty-three healthy and fully ambulatory patients were assessed, 11 women and 12 men, from 20 to 40 years
Acta ortop. bras.. Publicado em: 2014-10
-
9. Decompressive fasciotomy in testicular torsion of the spermatic cord in rats
PURPOSE: To evaluate the effect of decompression fasciotomy on testes undergoing torsion of the spermatic cord. METHODS: Spermatic cord torsion was induced in 40 Wistar testes for six and 12 hours. At the time of distortion, decompression fasciotomy was performed on half of the animals. After 42 days, the testicles were examined both macroscopically and micr
Acta Cir. Bras.. Publicado em: 2013-06
-
10. Análise experimental de três métodos de aerostasia bronquial.
The pulmonary lobectomy technique can be used on the lung cancer, lung lobe torsion, pulmonary laceration and lung abscesses treatment and among the postoperative problems the bronchial stump dehiscence, prolonged air leak and development of bronchopleural fistula are highlighted. These problems are usually resulting from malocclusion of the bronchial stump
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 29/02/2012
-
11. Flexural-torsional vibration analysis of axially loaded thin-walled beam
The present paper considers the flexure-torsion coupled vibrations of axially loaded thin-walled beams with arbitrary open cross section, by means of an exact solution. The effects of axial force, warping stiffness and rotary inertia are included in the present formulations. In the case of simply supported thin-walled beam, a closed-form solution for the cou
J. Braz. Soc. Mech. Sci. & Eng.. Publicado em: 2012-09
-
12. Comparison of the fracture torque of different Brazilian mini-implants
This study evaluated fracture torque by torsion, in relation to the length and diameter of orthodontic mini-implants, to demonstrate their viability for clinical and experimental use based on the torque recommended by the manufacturers. The fractures at the moment of insertion, whose incidence in the literature is around 4%, are principally due to excessive
Brazilian Oral Research. Publicado em: 2011-04