Transient Problems
Mostrando 1-12 de 85 artigos, teses e dissertações.
-
1. Estudo das Trincas Retas com o Método dos Elementos de Contorno, a Função de Green Numérica e a Técnica da Dupla Reciprocidade
RESUMO Nos últimos anos, o Método dos Elementos de Contorno (MEC) tem sido aplicado com sucesso a problemas da mecânica da fratura linear elástica (MFLE) envolvendo os casos estático e dinâmico. Para resolver problemas com ações de domínio (por exemplo: forças gravitacionais, problemas transientes com velocidades e acelerações, etc.) via MEC, Nar
TEMA (São Carlos). Publicado em: 10/06/2019
-
2. GFEM STABILIZATION TECHNIQUES APPLIED TO DYNAMIC ANALYSIS OF NON-UNIFORM SECTION BARS
Abstract The Finite Element Method (FEM), although widely used as an approximate solution method, has some limitations when applied in dynamic analysis. As the loads excite the high frequency and modes, the method may lose precision and accuracy. To improve the representation of these high-frequency modes, we can use the Generalized Finite Element Method (GF
Lat. Am. j. solids struct.. Publicado em: 29/10/2018
-
3. La acedia como forma de malestar en la sociedad actual
Based on Theunissen's proposition, we carried out an archeological investigation into the concept of melancholia in the ancient world and acedia in medieval times. In doing so we compare the concept to fatigue, boredom and sadness found in today's the culture. Charbonneau and Legrand (2003) called these problems paradepressions of problems, often infra-sympt
Rev. latinoam. psicopatol. fundam.. Publicado em: 2014-03
-
4. Distributed generators performance during short-circuits considering fault ride-through requirements / Desempenho de geradores distribuídos durante curtos-circuitos considerando requisitos de suportabilidade a afundamentos de tensão = : Distributed generators performance during short-circuits considering fault ride-through requirements
The increase of distributed generation penetration in distribution systems not only helps to diversify the electrical matrix but also brings both technical and economic benefits. Yet, it also raises worries related to energy supply reliability. For wind power plants into the medium and high voltage networks there are the grid codes for "Fault Ride-Through" w
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 03/08/2012
-
5. Transient wave propagation phenomena at visco-elastic half-spaces under distributed surface loadings
This article analyzes the transient wave propagation phenomena that take place at 2D viscoelastic half-spaces subjected to spatially distributed surface loadings and to distinct temporal excitations. It starts with a fairly detailed review of the existing strategies to describe transient analysis for elastic and viscoelastic continua by means of the Boundary
Lat. Am. j. solids struct.. Publicado em: 2012-08
-
6. Proposta de alocação de baterias em redes de sensores sem fio orientada à maximização do tempo de vida / Proposal of battery allocation on wireless sensor networks oriented to lifetime maximization
The recent advances in Wireless Sensor Networks technologies showed that while computational limitations are transient issues, energy limitations are much more complicated problems. In this work, a strategy aiming the lifetime increment of Wireless Sensor Networks is proposed. The main motivation of this work is that energy limitation is a serious inherent p
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 29/07/2011
-
7. âModelagem da IntrusÃo Salina Utilizando Analise de Sensitividade Adjunta â Estudo de Caso: Cap-Bon/Tunisiaâ / "Modeling of Saline Intrusion Using Sensitivity Analysis Assistant - Case Study: Cap-Bon/Tunisia"
Today the water is a natural well which limits the socioeconomic development and even the subsistence of the population. An attempt to minimize the problem of water scarcity has used the farming of groundwater. However, this growth of the use of groundwater was done inappropriately and with inadequate wells construction. This practice was eventually put at r
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 11/02/2011
-
8. Thermal effusivity estimation of polymers in time domain
An accurate knowledge of thermophysical properties is very important, for example, to optimize the engineering design and the development of new materials for many applications. Thermal effusivity is a thermal property which presents an increasing importance in heat conduction problems. This property indicates the amount of thermal energy that a material is
Journal of the Brazilian Society of Mechanical Sciences and Engineering. Publicado em: 2011-12
-
9. Simplified Mathematical Modeling for an Electromagnetic Forming System with Flat Spiral Coil as Actuator
This study presents mathematical modeling and calculation procedure for problems of electromagnetic forming of thin circular metal sheets using a flat spiral coil as actuator. The methodbased on the Biot-Savart Law focuses specifically on the calculation of the electromagnetic field generated by the flat coil and analysis of the circuit that models the elect
Journal of the Brazilian Society of Mechanical Sciences and Engineering. Publicado em: 2011-09
-
10. A proposal for optimized analysis of transient currents in conductive materials. / Uma proposta para análise otimizada de correntes transitórias em materiais condutores.
In this work, a methodology is developed, based on the application of the moment method associated to a finite difference approximation, for time domain analysis of transient current distribution in conducting media. The computational procedure allows that long conductors with any cross section can be considered, approximated by filamentary elements. Thus, t
Publicado em: 2010
-
11. Determinação da distribuição de temperatura transiente no tempo em elementos estruturais utilizando o metodo dos elementos de contorno / Determination of transient temperature distribution in structural elements using the boundary elements method
The Boundary Elements Method was employed in the study of the transient effect of the temperature in heat conduction problems for plain elements. The purpose was to present a formulation using linear continuous or discontinuous boundary elements with nodal parameters fixed at the ends of elements. The collocations points were positioned at the ends of contin
Publicado em: 2009
-
12. Estudos de processos térmicos decorrentes da usinagem: aplicação de problemas inversos em furação / Thermal studies of cutting process. Inverse problem application in drilling
Heat generation is a common problem during any type of cutting, but particularly during a drilling due to the difficulty of conducting heat away from the cutting edge and the fact that the chips remain in contact with the tool for a relatively long time in a hole. Cutting temperatures have strongly influenced both the tool life and the metallurgical state of
Publicado em: 2009