Weibull Model
Mostrando 1-12 de 69 artigos, teses e dissertações.
-
1. Tadalafil-loaded PLGA microspheres for pulmonary administration: preparation and evaluation
Tadalafil, a long-acting PED-5 inhibitor, is commonly used for the treatment of pulmonary arterial hypertension (PAH). However, its efficacy and clinical application are severely limited by the poor water solubility, low bioavailability and a series adverse effects (e.g. headaches, indigestion). In this study, tadalafil was prepared and loaded into biodegrad
Braz. J. Pharm. Sci.. Publicado em: 20/12/2019
-
2. Estimativa da resistência característica à tração da madeira na direção paralela às fibras por meio de modelos probabilísticos
RESUMO Para um dimensionamento de estruturas de madeiras dentro das exigências de segurança, a resistência para determinada solicitação mecânica é calculada com base em seu valor característico, correspondente ao percentil de 5% de um determinado modelo de distribuição de probabilidades. A norma brasileira NBR 7190 [1] estabelece, para pequenas amo
Matéria (Rio J.). Publicado em: 25/11/2019
-
3. Modeling of probability in obtaining intensity-duration-frequency relationships of rainfall occurrence for Pelotas, RS, Brazil
RESUMO Com base em séries históricas, para cada localidade, equações podem caracterizar a relação entre a intensidade, duração e frequência de ocorrência de precipitação pluvial. Objetivou-se apresentar duas equações para a localidade de Pelotas, RS, no período de 1982-2015, uma denominada convencional e outra híbrida, dependendo do modelo pr
Rev. bras. eng. agríc. ambient.. Publicado em: 10/07/2019
-
4. Microstructure and Weibull distribution of rupture strength of clay-talc ceramics
Resumo As propriedades mecânicas das cerâmicas de argila-talco contendo 0 a 10% em massa de talco sinterizadas a 1100 °C foram obtidas por medidas de flexão. Com o valor médio de resistência à flexão de 23,1 MPa, a amostra com 5% de talco (G5) foi a mais forte e apresentou o menor valor de poro interconectado (64%). A dispersão dos valores de resist
Cerâmica. Publicado em: 06/06/2019
-
5. Fatigue Failure Analysis on Precracked 304 Stainless Steel Components Repaired by Laser with Addition of Nanocomposites
Abstract The service life of components can be extended by repairing fatigue crack with laser so as to improve resource utilization rate. However, the effect of laser repair may be influenced by the instability of laser treatment. To investigate the addition of nanocomposites on the laser repairing effect, fatigue test under uniaxial tension was carried out
Soldag. insp.. Publicado em: 16/05/2019
-
6. Allometric models to estimate tree height in northern Amazonian ecotone forests
RESUMO Modelos alométricos que definem o relacionamento entre diâmetro do tronco e a altura total da árvore na bacia amazônica são importantes porque refinam as estimativas de fluxo e estoques de carbono arbóreo na região. Este estudo testou diferentes modelos alométricos para estimar a altura total de árvores a partir do diâmetro do tronco em uma
Acta Amaz.. Publicado em: 06/05/2019
-
7. A new class of lifetime models and the evaluation of the confidence intervals by double percentile bootstrap
Abstract: In this paper, we introduce a new three-parameter distribution by compounding the Nadarajah-Haghighi and geometric distributions, which can be interpreted as a truncated Marshall-Olkin extended Weibull. The compounding procedure is based on the work by Marshall and Olkin 1997. We prove that the new distribution can be obtained as a compound model w
An. Acad. Bras. Ciênc.. Publicado em: 08/04/2019
-
8. Modeling the individual height and volume of two integrated crop-livestock-forest systems of Eucalyptus spp. in the Brazilian Savannah
ABSTRACT. The aim of this study was to model the individual height and volume of eucalyptus wood in two integrated crop-livestock-forest systems (ICLF1 and ICLF2) in Campo Grande, a city in the state of Mato Grosso do Sul, Brazil. Classic nonlinear growth models were adjusted for height (Logistic, Gompertz, Richards, Weibull, Van Bertalanffy, Brody, Mitscher
Acta Sci., Agron.. Publicado em: 28/03/2019
-
9. ESTIMATION OF THE CHARACTERISTIC VALUE OF WOOD STRENGTH
ABSTRACT For safety reasons, wood strength values, essential for structural dimensioning, are calculated based on the characteristic value, which corresponds to the 5% percentile of a given probability distribution model. For small samples, the Brazilian normative document ABNT NBR 7190 establishes an estimator of the characteristic wood strength, which can
Eng. Agríc.. Publicado em: 2019-02
-
10. Adjusting weight growth curve of male quails Coturnix japonica reared in the semi-arid region of the State of Pernambuco
ABSTRACT. This study adjusted different regression models to describe the growth pattern of meat quails from birth to 42 days of age. Data of 300 male quails were used. Weight and height information of all quails were collected weekly from the 1st to the 42nd day of age. Body weight of poultry was subjected to the polynomial, logistic, Gompertz, Weibull, an
Acta Sci., Anim. Sci.. Publicado em: 07/01/2019
-
11. Phenotypic relationships between type traits and productive life using a piecewise Weibull proportional hazard model
ABSTRACT: Longevity is an important trait due to its relationship with profitability. Type traits have been used as indirect predictors for productive life. The objective of this study was to evaluate the relationship of 20 type traits on length of productive life in Brazilian Holsteins, using a piecewise Weibull proportional hazard model. Three analyses wer
Sci. agric. (Piracicaba, Braz.). Publicado em: 2018-12
-
12. Kinetics and Thermodynamics of Thermal Inactivation of β-Galactosidase from Aspergillus oryzae
ABSTRACT For optimization of biochemical processes in food and pharmaceutical industries, the evaluation of enzyme inactivation kinetic models is necessary to allow their adequate use. Kinetic studies of thermal inactivation of β-galactosidase from Aspergillus oryzae were conducted in order to critically evaluate mathematical equations presented in the lite
Braz. arch. biol. technol.. Publicado em: 13/09/2018